ISO INTERNATIONAL STANDARD 6361-1 Second edition 2011-08-15 Wrought aluminium and aluminium alloys Sheets, strips and plates Part 1: Technical conditions for inspection and delivery Aluminium et alliages d'aluminium corroyés - Toles, bandes et toles épaisses Partie 1: Conditions techniques de controle et de livraison Reference number ISO 6361-1:2011(E) @ ISO 2011 IHS unde Not for Resale ISO 6361-1:2011(E) COPYRIGHTPROTECTEDDOCUMENT @ISO2011 All rights reserved. Unless otherwise specified, no part of this publication may be reproduced or utilized in any form or by any means, electronic or mechanical, including photocopying and microfilm, without permission in writing from either isO at the address below or Iso's member body in the country of the requester. ISO copyright office Case postale 56 . CH-1211 Geneva 20 Tel. + 41 22 749 01 11 Fax + 41 22 749 09 47 E-mail copyright@iso.org Web www.iso.org Published in Switzerland @ ISO 2011 - All rights reserved itted without license from IHS Not for Resale ISO 6361-1:2011(E) Contents Page Foreword .iv 1 Scope 2 Normative references 3 Terms and definitions .. 4 Orders or tenders 5 Requirements.. 5.1 Production and manufacturing processes 5.2 Quality control. 5.3 Chemical composition.. 5.4 Mechanical properties.. 5.5 Corrosion behaviour .. 5.6 5.7 Dimensionaltolerances 6 Test procedure 6.1 Sampling 6.2 Test methods 6.3 Retests..... 7 Inspection documents 7.1 General 7.2 Certificate of conformity 7.3 10 7.4 Specific test report. 10 8 Marking 10 9 Packing 10 Arbitration tests.... Copyrght InternationalOrganizaionStandardizaonghtsreserved ii from IHS Not for Resale