ISO INTERNATIONAL STANDARD 7240-10 Second edition 2012-05-15 Fire detection and alarm systems - Part 10: Point-type flame detectors Systemes de detection et d'alarme d'incendie - Partie 10: Détecteurs de flammes ponctuels Reference number ISO 7240-10:2012(E) ISO @ISO2012 No reproduction or networking permitted without license from IHS Not for Resale ISO 7240-10:2012(E) COPYRiGHTPROTECTEDDOCUMENT ISO 2012 All rights reserved. Unless otherwise specified, no part of this publication may be reproduced or utilized in any form or by any means, electronic or mechanical, including photocopying and microfilm, without permission in writing from either ISO at the address below or ISO's member body in the country of the requester. ISO copyright office Case postale 56 · CH-1211 Geneva 20 Tel. + 41 22 749 01 11 Fax + 41 22 749 09 47 E-mail copyright@iso.org Web www.iso.org Published in Switzerland ISO 2012-All rights reserved or networking permited withoutlicense from IHS Not for Resale ISO 7240-10:2012(E) Contents Page Foreword ..iv Introduction vi 1 Scope. 2 Normative references 3 Terms and definitions. 4 Abbreviated terms. 5 General requirements.. 5.1 Compliance.. 3 5.2 Classification.. 3 5.3 Individualalarmindication 3 5.4 Connectionofancillarydevices 3 5.5 Monitoring of detachable detectors 5.6 Manufacturer adjustments. 3 5.7 On-site sensitivity adjustment 5.8 Ingress protection (IP) Optional function 5.9 Marking.. 5.10 Data... 5 5.11 Requirements for software-controlled detectors 5 6 Tests. 6 6.1 General 6.2 6 Reproducibility. 6.3 Repeatability 10 6.4 Directional dependence 10 6.5 Fire sensitivity... 11 6.6 Dazzling (operational) 14 6.7 Dry heat (operational). 15 6.8 Cold (operational). 16 6.9 Damp heat, cyclic (operational) 16 6.10 Damp heat, steady state (endurance) 17 6.11 Sulfur dioxide (SO2) corrosion (endurance) 18 6.12 Shock (operational).. 19 6.13 Impact(operational) 20 6.14 Vibration, sinusoidal (operational) 21 6.15 Vibration, sinusoidal (endurance) 22 6.16 Variation of supply parameters (operational) 23 6.17 EMC immunity tests (operational) 23 6.18 IP - Optional function.... 24 7 Test report. 25 Annex A (normative) Apparatus for response point determination. .26 Annex B (normative) Liquid (heptane) fire (TF5). .28 Annex C (normative) Liquid (methylated spirit) fire (TF6), .29 Annex D (normative) Apparatus for dazzling test. .30 Annex E (normative) Apparatus for impact test. .31 Annex F (informative) Example of methane burner. 33 ili e with IS ed without license from IHS Not for Resale

.pdf文档 ISO 7240-10 2012 Fire detection and alarm systems — Part 10 Point-type flame detectors

文档预览
中文文档 43 页 50 下载 1000 浏览 0 评论 309 收藏 3.0分
温馨提示:本文档共43页,可预览 3 页,如浏览全部内容或当前文档出现乱码,可开通会员下载原始文档
ISO 7240-10 2012 Fire detection and alarm systems — Part 10  Point-type flame detectors 第 1 页 ISO 7240-10 2012 Fire detection and alarm systems — Part 10  Point-type flame detectors 第 2 页 ISO 7240-10 2012 Fire detection and alarm systems — Part 10  Point-type flame detectors 第 3 页
下载文档到电脑,方便使用
本文档由 人生无常 于 2024-08-31 15:04:57上传分享
站内资源均来自网友分享或网络收集整理,若无意中侵犯到您的权利,敬请联系我们微信(点击查看客服),我们将及时删除相关资源。