FINAL INTERNATIONAL ISO/FDIS DRAFT STANDARD 7625 ISO/TC119/SC3 Sintered metal materials, excluding Secretariat: DIN hardmetals Preparation of Voting begins on: samples for chemical analysis for 2012-08-30 determination of carbon content Voting terminates on: 2012-10-30 Materiaux metalliques frittes, a I'exclusion des métaux-durs Préparation des échantillons pour analyse chimique en vue du dosage du carbone Please see the administrative notes on page ii RECIPIENTS OF THIS DRAFT ARE INVITED TO SUBMIT, WITH THEIR COMMENTS, NOTIFICATION OF ANY RELEVANT PATENT RIGHTS OF WHICH THEY ARE AWARE AND TO PROVIDE SUPPORTING DOCUMENTATION Reference number BEING ACCEPTABLE FOR INDUSTRIAL, TECHNO- LOGICAL, COMMERCIAL AND USER PURPOSES ISO/FDIS 7625:2012(E) ISO OCCASION HAVE TO BE CONSIDERED IN THE LIGHT OFTHEIR POTENTIALTO BECOME STAN DARDS TO WHICH REFERENCE MAY BE MADE IN NATIONAL REGULATIONS @ISO2012 Provided by IHS Not for Resale IS0/FDIS 7625:2012(E) Copyright notice This ISO document is a Draft International Standard and is copyright-protected by ISO. Except as permitted under the applicable laws of the user's country, neither this IsO draft nor any extract from it may be reproduced, stored in a retrieval system or transmitted in any form or by any means electronic, photocopying, recording or otherwise, without prior written permission being secured. Requests for permission to reproduce should be addressed to either IsO at the address below or IsO's member body in the country of the requester. ISO copyright office Case postale 56 . CH-1211 Geneva 20 Tel.+41227490111 Fax+41227490947 E-mail [email protected] Web www.iso.org Reproduction may be subject to royalty payments or a licensing agreement. Violators may be prosecuted. ii @ IS0 2012 - All rights reserved ense from IHS Not for Resale IS0/FDIS 7625:2012(E) ISO/CEN PARALLEL PROCESSING This final draft has been developed within the International Organization for Standardization (IsO), and pro- cessed under the Iso-lead mode of collaboration as defined in the Vienna Agreement. The final draft was established on the basis of comments received during a parallel enquiry on the draft. This final draft is hereby submitted to the ISO member bodies and to the CEN member bodies for a parallel two-month approval vote in ISO and formal vote in CEN. Positive votes shall not be accompanied by comments. Negative votes shall be accompanied by the relevant technical reasons. @ IS0 2012 - All rights reserved iii Provided by IHS No reproduction or networking permitted without license from IHS Not for Resale