ISO INTERNATIONAL STANDARD 11699-1 Second edition 2008-09-15 Non-destructive testing Industrial radiographic film - Part 1: Classification of film systems for industrial radiography Essais non destructifs-Filmpour radiographie industrielle- Partie 1: Classification des systemes filmspour radiographie industrielle Reference number ISO 11699-1:2008(E) @ ISO 2008 IHS under Not for Resi ISO 11699-1:2008(E) PDF disclaimer This PDF file may contain embedded typefaces. In accordance with Adobe's licensing policy, this file may be printed or viewed but shall not be edited unless the typefaces which are embedded are licensed to and installed on the computer performing the editing. In accepts no liability in this area. Adobe is a trademark of Adobe Systems Incorporated. Details of the software products used to create this PDF file can be found in the General Info relative to the file; the PDF-creation parameters were optimized for printing. Every care has been taken to ensure that the file is suitable for use by IsO member bodies. In the unlikely event that a problem relating to it is found, please inform the Central Secretariat at the address given below. COPYRIGHTPROTECTEDDOCUMENT @ ISO2008 All rights reserved. Unless otherwise specified, no part of this publication may be reproduced or utilized in any form or by any means, electronic or mechanical, including photocopying and microfilm, without permission in writing from either isO at the address below or IsO's member body in the country of the requester. ISO copyright office Case postale 56. CH-1211 Geneva 20 Tel. + 4122 749 01 11 Fax + 41 22 749 09 47 E-mail [email protected] Web www.iso.org Published in Switzerland @ ISo 2008 - All rights reserved I without license from IHS Not for Resale ISO 11699-1:2008(E) Foreword IsO (the International Organization for Standardization) is a worldwide federation of national standards bodies established has the right to be represented on that committee. International organizations, governmental and International Electrotechnical Commission (IEC) on all matters of electrotechnical standardization. International Standards are drafted in accordance with the rules given in the ISO/lEC Directives, Part 2. adopted by the technical committees are circulated to the member bodies for voting. Publication as an International Standard requires approval by at least 75 % of the member bodies casting a vote. Attention is drawn to the possibility that some of the elements of this document may be the subject of patent rights. IsO shall not be held responsible for identifying any or all such patent rights. ISO 11699-1 was prepared by Technical Committee ISO/TC 135, Non-destructive testing, Subcommittee SC 5, Radiation methods. This second edition cancels and replaces the first edition (IsO 11699-1:1998), which has been technically revised. radiographic film: Part 1: Classification of film systems for industrial radiography Part 2: Control of filmprocessing by means of reference values al organizationforstandardizllon'ghts reserved ili