ISO INTERNATIONAL STANDARD 8566-3 Second edition 2010-02-01 Cranes Cabins and control stations - Part 3: Tower cranes Appareils de levage a charge suspendue - Cabines et postes de conduite Partie 3: Grues a tour Reference number ISO 8566-3:2010(E) @ ISO 2010 yIHSunder itted without license from IHS Not for Resale ISO 8566-3:2010(E) PDF disclaimer This PDF file may contain embedded typefaces. In accordance with Adobe's licensing policy, this file may be printed or viewed but shall not be edited unless the typefaces which are embedded are licensed to and installed on the computer performing the editing. In accepts no liability in this area. Adobe is a trademark of Adobe Systems Incorporated. Details of the software products used to create this PDF file can be found in the General Info relative to the file; the PDF-creation parameters were optimized for printing. Every care has been taken to ensure that the file is suitable for use by IsO member bodies. In the unlikely event that a problem relating to it is found, please inform the Central Secretariat at the address given below. COPYRIGHT PROTECTED DOCUMENT ISO2009 All rights reserved. Unless otherwise specified, no part of this publication may be reproduced or utilized in any form or by any means, electronic or mechanical, including photocopying and microfilm, without permission in writing from either isO at the address below or ISO's member body in the country of the requester. ISO copyright office Case postale 56 . CH-1211 Geneva 20 Tel. + 4122 749 01 11 Fax + 41 22 749 09 47 E-mail [email protected] Web www.iso.org Published in Switzerland @ ISO 2010 - All rights reserved without license from IHS Not for Resale ISO 8566-3:2010(E) Foreword IsO (the International Organization for Standardization) is a worldwide federation of national standards bodies technical committees. Each member body interested in a subject for which a technical committee has been International Electrotechnical Commission (IEC) on all matters of electrotechnical standardization. International Standards are drafted in accordance with the rules given in the ISO/lEC Directives, Part 2. The main task of technical committees is to prepare International Standards. Draft International Standards adopted by the technical committees are circulated to the member bodies for voting. Publication as an International Standard requires approval by at least 75 % of the member bodies casting a vote. rights. IsO shall not be held responsible for identifying any or all such patent rights. This second edition cancels and replaces the first edition (IsO 8566-3:1992), which has been technically revised IsO 8566 consists of the following parts, under the general title Cranes Cabins and control stations: Part 1: General Part 2: Mobile cranes Part 3: Towercranes Part 4: Jib cranes Part 5:Overhead travelling and portal bridge cranes @ Iso 2010 - All rights reserved ili