ISO INTERNATIONAL STANDARD 8729-1 First edition 2010-01-15 Ships and marine technology Marine radar reflectors - Part 1: Passive type Navires et technologie maritime Reflecteurs radars de marine - Partie 1: Reflecteurs de type passif Reference number ISO 8729-1:2010(E) @ ISO 2010 by IHS under lic Not for Resale ISO 8729-1:2010(E) PDF disclaimer This PDF file may contain embedded typefaces. In accordance with Adobe's licensing policy, this file may be printed or viewed but shall not be edited unless the typefaces which are embedded are licensed to and installed on the computer performing the editing. In accepts no liability in this area. Adobe is a trademark of Adobe Systems Incorporated. Details of the software products used to create this PDF fle can be found in the General Info relative to the file; the PDF-creation parameters were optimized for printing. Every care has been taken to ensure that the file is suitable for use by IsO member bodies. In the unlikely event that a problem relating to it is found, please inform the Central Secretariat at the address given below COPYRIGHT PROTECTED DOCUMENT ISO2010 All rights reserved. Unless otherwise specified, no part of this publication may be reproduced or utilized in any form or by any means isO's member body in the country of the requester. ISO copyright office Case postale 56 . CH-1211 Geneva 20 Tel. + 41 22 749 01 11 Fax + 41 22 749 09 47 E-mail [email protected] Web www.iso.org Published in Switzerland @ ISO 2010 - All rights reserved ed without license from IHS Not for Resale ISO 8729-1:2010(E) Contents Page Foreword .iv 1 Scope 2 Normative references 3 Terms and definitions 4 Construction ... 4.1 Structure and materials 4.2 Enclosed size of the reflector for small-craft 4.3 5 Performance requirements 5.1 General requirements .. 5.2 Reflecting pattern in horizontal plane... 5.3 Environmental requirements..... 6 Inspectionandtypetests 6.1 Visualinspection 6.2 Test site... 6.3 Environmental tests 6.4 Performancetests. 6.5 Mechanical strength test 7 Installation 7.1 Method.. 7.2 Positioning check. 7.3 Mounting height check 7.4 Mass check... 7.5 Size check .. 8 Manual .. 9 Marking... .6 Annex A (normative) Mounting height of the reflectors . Annex B (informative) Example diagrams. .9 AnnexC(informative)Statedperformancelevel... 11 Annex D (informative) Equivalent requirements in this part of ISO 8729 and IMO Resolution MSC. .64.(78. ...... 12 Bibliography. 13 Copyright internatinal Oorganizaio for Standardizalion ghts reserved ii Not for Resale