ISO/TR TECHNICAL REPORT 10064-6 First edition 2009-02-15 Code of inspection practice - Part 6: Bevel gear measurement methods Code pratique de réception- Partie 6: Methodes de mesure des engrenages coniques Reference number ISO/TR 10064-6:2009(E) @ ISO 2009 by IHS under lic itted without license from IHS Not for Resale ISO/TR 10064-6:2009(E) PDF disclaimer This PDF file may contain embedded typefaces. In accordance with Adobe's licensing policy, this file may be printed or viewed but shall not be edited unless the typefaces which are embedded are licensed to and installed on the computer performing the editing. In accepts no liability in this area. Adobe is a trademark of Adobe Systems Incorporated. Details of the software products used to create this PDF file can be found in the General Info relative to the file; the PDF-creation parameters were optimized for printing. Every care has been taken to ensure that the file is suitable for use by IsO member bodies. In the unlikely event that a problem relating to it is found, please inform the Central Secretariat at the address given below COPYRIGHTPROTECTEDDOCUMENT @ ISO2009 All rights reserved. Unless otherwise specified, no part of this publication may be reproduced or utilized in any form or by any means, IsO's member body in the country of the requester. ISO copyright office Case postale 56. CH-1211 Geneva 20 Tel. + 41 22 749 01 11 Fax + 41 22 749 09 47 E-mail [email protected] Web www.iso.org Published in Switzerland @ ISO 2009 - All rights reserved ed without license from IHS Not for Resale ISO/TR 10064-6:2009(E) Contents Page Foreword. iv 1 Scope 2 Normative references 3 Terms, definitions and symbols.... 3.1 Terms and definitions ... 3.2 Symbols......... .3 4 Bevel gear measurement 4.1 Manufacturing and purchasing considerations ..... 4.2 Manufacturing documentation . 4.3 Process control... 4.4 Measurement methods. .5 4.5 Additional considerations.. 4.6 Acceptance criteria.. 5 Measuring methods and practices.. 5.1 Guidelines for measurement of gear characteristics.. 5.2 Measuring practices ... 5.3 Measurement of pitch deviations 10 5.4 Measurement of bevel gear runout.. 16 5.5 Flank form measurement... .18 5.6 Contact pattern checking...... 5.7 Single-flank composite inspection .30 5.8 Double-flank composite testing, 30 5.9 Tooth thickness measurement... 33 5.10 Manufacturing applications .. .36 6 Recommended datum surface tolerance ..36 Bibliography 37 CopyrghtInternationalOrganizaionsadardizaoghtsreserved ii ted without license from IHS Not for Resale