ISO/TR TECHNICAL REPORT 11954 First edition 2008-10-15 Fuelcellroadvehicles 一Maximum speedmeasurement VehiculesroutiersapileacombustibleMesuredelavitesse maximale Reference number ISO/TR 11954:2008(E) @ISO2008 ted without license from IHS Not for Resale ISO/TR11954:2008(E) PDFdisclaimer This PDF file may contain embedded typefaces. In accordance with Adobe's licensing policy, this file may be printed or viewed but shall not be edited unless the typefaces which are embedded are licensed to and installed on the computer performing the editing. In accepts noliabilityinthisarea. Adobe is a trademark of Adobe Systems Incorporated. Details of the software products used to create this PDF file can be found in the General Info relative to the file; the PDF-creation parameters were optimized for printing. Every care has been taken to ensure that the file is suitable for use by IsO member bodies. In the unlikely event that a problem relating to it is found, please inform the Central Secretariat at the address given below. COPYRIGHTPROTECTEDDOCUMENT ?ISO2008 All rights reserved. Unless otherwise specified, no part of this publication may be reproduced or utilized in any form or by any means, electronic or mechanical, including photocopying and microfilm, without permission in writing from either isO at the address below or isO's memberbody in the country of the requester. ISO copyright office Casepostale56.CH-1211Geneva20 Tel.+ 4122749 0111 Fax + 41 22 749 09 47 E-mail [email protected] Web www.iso.org Published inSwitzerland ISO 2008 -All rights reserved without license from IHS Not for Resale ISO/TR11954:2008(E) Foreword IsO (the International Organization for Standardization) is a worldwide federation of national standards bodies (IsO member bodies). The work of preparing International Standards is normally carried out through IsO technicalcommittees.Eachmemberbodyinterestedinasubjectforwhichatechnicalcommitteehasbeer non-governmental, in liaison with isO, also take part in the work. iso collaborates closely with the International Electrotechnical Commission (IEC) on all matters of electrotechnical standardization. International Standards are drafted in accordance with the rules given in the ISO/lEC Directives, Part 2. The main task of technical committees is to prepare International Standards. Draft International Standards adopted by the technical committees are circulated to the member bodies for voting. Publication as an International Standard requiresapproval byat least75%of thememberbodiescastingavote. In exceptional circumstances, when a technical committee has collected data of a different kind from that informative in nature and does not have to be reviewed until the data it provides are considered to be no longervalid oruseful. Attention is drawn to the possibility that some of the elements of this document may be the subject of patent rights. isO shall not be held responsible for identifying any or all such patent rights. ISO/TR11954waspreparedbyTechnicalCommitteeISO/TC22,Roadvehicles,SubcommitteeSC21, Electricallypropelledroadvehicles.