ISO INTERNATIONAL STANDARD 10097-1 First edition 1999-10-15 Wireline diamond core drilling equipment - System A - Part 1: Metric units Equipement de forage au diamant a ligne a cable avec carottage SystemeA- Partie 1: Unités métriques ISO Reference number ISO 10097-1:1999(E) ISO 10097-1:1999(E) Contents 1 Scope 2 Normative reference, 3Designatioi 4Materials 2 5 Dimensions and tolerances 2 5.1General 5.2 Conformity.. 5.3 Eccentricity. 5.4Straightness 5.5 Technical conditions. Annex A (informative) Principal dimensions of drill rod threads @ISO1999 All rights reserved. Unless otherwise specified, no part of this publication may be reproduced or utilized in any form or by any means, electronic InternationalOrganizationforStandardization Casepostale56·CH-1211Geneve20·Switzerland Internet [email protected] Printed in Switzerland ii @ISO ISO 10097-1:1999(E) Foreword ISO(theInternationalOrganizationforStandardization)isaworldwidefederationofnationalstandardsbodies(lSo member bodies). The work of preparing International Standards is normally carried out through IsO technical committees. Each member body interested in a subject for which a technical committee has been established has liaison with isO, also take part in the work. IsO collaborates closely with the International Electrotechnical Commission (IEC) on all matters of electrotechnical standardization. International Standards are drafted in accordance with the rules given in the ISO/lEC Directives, Part 3. Draft International Standards adopted by the technical committees are circulated to the member bodies for voting. Publication as an International Standard requires approval by at least 75 % of the member bodies casting a vote. SC 6, Diamond core drilling equipment. Iso 10097 consists of the following parts, under the general title Wireline diamond core drilling equipment - System A: 一Part 1:Metric units Part 2: Inch units Annex A of this part of ISO 10097 is for information only. ili