ISO INTERNATIONAL STANDARD 10303-510 First edition 2000-03-01 Industrial automation systems and integration Product data representation and exchange - Part 510: Application interpreted construct: Geometrically bounded wireframe Systemes d'automatisation industrielle et integration-Représentation et échange de données de produits - Partie 510: Construction interprétée d'application: Cadre en fil métallique délimite geometriquement Reference number E ISO 10303-510:2000(E) ISO @ ISO 2000 Not for Resale ISO 10303-510:2000(E) PDF disclaimer This PDF file may contain embedded typefaces. In accordance with Adobe's licensing policy, this file may be printed or viewed but shall not be edited unless the typefaces which are embedded are licensed to and installed on the computer performing the editing. In downloading this area. Adobe is a trademarkof Adobe Systems Incorporated. Details of the software products used to create this PDF file can be found in the General Info relative to the file; the PDF-creation parameters were optimized for printing. Every care has been taken to ensure that the file is suitable for use by ISO member bodies. In the unlikely event ?ISO2000 All rights reserved. Unless otherwise specified, no part of this publication may be reproduced or utilized in any form or by any means, electronic or mechanical, including photocopying and microfilm, without permission in writing from either ISO at the address below or ISO's member body in the country of the requester. ISO copyright office Case postale 56. CH-1211 Geneva 20 Tel. + 41 22 749 01 11 Fax + 41 22 734 10 79 E-mail [email protected] Web www.iso.ch Printed in Switzerland @Iso2000-All rightsreserved ermittedwithoutlicense from IHS Not for Resale ISO 10303-510:2000(E) CISO Contents Page 1 Scope 2 Normative references 3 Definitions and abbreviations 3.1 Terms defined in ISO 10303-1 3.2 Terms defined in ISO 10303-202 3.3 Abbreviations 4 EXPRESS short listing 4.1 Introduction 4.2 Fundamental concepts and assumptions 4.3 aic_geometrically_bounded_wireframe entity definition: geometrically_bounded_wireframe_shape_representation 4.4 aic_geometrically_bounded_wireframe function definitions 4.4.1 valid_geometrically_bounded_wf_curve 4.4.2 valid_geometrically_bounded_wf_point Annex A (normative) Short names of entities Annex B (normative) Information object registration . 11 B.1 Document identification 11 B.2 Schema identification 11 Annex C (informative) EXPRESS-G diagrams 12 Annex D (informative) Computer interpretable listings 19 Index 20 ii Copyright Intemational Organizatior No repr rom IHS Not for Resale