48519030753837319 STD.IS0 12085-ENGL 1996 INTERNATIONALSTANDARDISO12085:1996 TECHNICALCORRIGENDUM1 ISo Published 1998-06-15 Geometrical Product Specifications (GPS) - Surface texture: Profile method -- Motif parameters TECHNICALCORRIGENDUM1 RECTIFICATIF TECHNIQUE 1 IsO/Tc 213, Dimensional and geometrical product specifications and verification. This material is reproduced from IsO doc Imentsunder International Organizationfor Standardization (ISO) Copyright License Number IHS/ICC/1996,Not for resate.No part of these IsO documents may be reproduced in any form, electronic rerleval system or otherwise, except as allowed in the copyright law of the country of use, or with the prior writen consent of ISO (Case postale 56, 1211 Geneva 20, Switzerland, Fax +41 22 734 10 79), IHS or the [SO Licensor's members. Page 1 Clause 2 Replace “SO 4287:1996" with "ISO 4287:1997". Page 17 Figure C.1 Replace Data" with “Datums". ICS 17.040.20 Ref. No. ISO 12085:1996/Cor.1:1998(E) Descriptors: surface condition, surtace waviness, roughness, roughness measurement, profiles, identification methods. @ISO1998 Printed in Switzerland Copyright International Organization for Standardization Not for Resale 4851903 0671624 T61 1208596 INTERNATIONAL ISO STANDARD 12085 First edition 1996-08-15 Geometrical Product Specification (GPS) Surface texture: Profile method - Motif parameters Specification geométrique des produits (GPS) - Etat de surface: Methode duprofil-Parametres liésauxmotifs This material is reproduced from Iso documents under Internationa! Organization for Standardization (Iso) Copyright License number IHS/ICC/1996. Not for resale. No part of these Iso documents may be reproduced in any form, electronic retrieval system or otherwise, except as allowed in the copyright law of the country of use, or with the prior written consent of Iso (Case postale 56, 1211 Geneva 20, switzerland, Fax +41 22 7341079),IHsortheisoLicensor'smembers. ISO Reference number ISO 12085:1996(E) Copyright Intermational Organization for Standardization I by IHS with ISC Not for Resale 1208596 4851903 0671625 9T8 ISO 12085:1996(E) Contents Page 1 Scope.. 1 2 Normative references. 1 3 Definitions 1 3.1 General definitions 1 3.2 Parameter definitions .. 3 Theoretically exact operator of the motif method. 5 4.1 General.. 5 4.2 Conventional limits of motifs... 5 4.3 Depth discrimination . 5 4.4 identification of roughness and waviness motifs through the combination of motifs .. 8 4.5 Procedure for parameter calculation . 10 5Measuring conditions of parameters.. 12 5.1 Convention concerning traversing the primary profile ... 12 5.2 Recommended measurement conditions.. 12 5.3 Profile quantization step. 12 5.4. Rule for acceptance.... 12 5.5 Use of motifs method for analysis of multiprocess surfaces....... 12 5.6 Indications on the drawings 12 CISO1996 All rights reserved. Unless otherwise specified, no part of this publication may be repro- duced or utilized in any form or by any means, electronic or mechanical, including photo- copying and microfilm, without permission in writing from the publisher. International Organizationfor Standardization CasePostale56·CH-1211Geneve20-Switzerland Printed in Switzerland Not for Resale