ISO INTERNATIONAL STANDARD 2338 Second edition 1997-11-01 Parallel pins, of unhardened steel and austenitic stainless steel Goupilles cylindriques en acier non trempé et en acier inoxydable austenitique This material is reproduced from Iso documents under International Organization for Standardization (Iso) Copyright License number IHS/ICC/1996. Not for resale. No part of these ISO documents may be reproduced in any form, electronic retrieval system or otherwise, except as allowed in the copyright law of the country of use, or with the prior written consent of Iso (Case postale 56, 1211 Geneva 20, Switzerland, Fax +41 22 7341079),IHSortheISoLicensorsmembers. ISO Reference number ISO 2338:1997(E) Copyright Intermational Organization for Standardization No reproduction or networking permitted without license from IHS Not for Resale ISO 2338:1997(E) Foreword IsO (the International Organization for Standardization) is a worldwide federation of national standards bodies (IsO member bodies). The work of preparing International Standards is normally carried out through ISsO technical committees. Each member body interested in a subject for which a technical committee has been established has the right to be represented on that committee. International organizations, governmenta! and non- governmental, in liaison with ISO, also take part in the work. ISO collaborates closely with the International Electrotechnical Commission (IEC) on all matters of electrotechnical standardization. Draft International Standards adopted by the technical committees are circulated to the member bodies for voting. Publication as an International a vote. International Standard ISO 2338 was prepared by Technical Committee ISO/TC 2, Fasteners. This second edition cancels and replaces the first edition (Is0 2338:1986), which has been technically revised. @ISO1997 All rights reserved. Unless otherwise specified, no part of this publication may be reproduced microfilm, without permission in writing from the publisher. International OrganizationforStandardization Case postale 56 . CH-1211 Geneve 20 . Switzerland Internet [email protected] X.400 C=ch;a=400net; p=iso;o=isocs; S=central Printed in Switzerland = nal Organization for Standardization Not for Resale INTERNATIONAL STANDARD @ISO ISO 2338:1997(E) Parallel pins, of unhardened steel and austenitic stainless steel 1 Scope This International Standard specifies the characteristics of parallel pins of unhardened steel and austenitic stainlesssteel,withnominaidiametersdfrom0,6mmto5omminclusive. 2 Normative references The following standards contain provisions which, through reference in this text, constitute provisions of this International Standard. At the time of publication, the editions indicated were valid. All standards are subject to revision, and parties to agreements based on this International Standard are encouraged to investigate the possibility of applying the most recent editions of the standards indicated below. Members of IEc and ISO maintain registers of currently valid International Standards IsO 3269:1988, Fasteners -Acceptance inspection. Iso 3506-1:1997, Mechanical properties of corrosion-resistant stainless steel fasteners - Part 1: Bolts, screws and studs. Iso 4042:", Fasteners -- Electroplated coatings. Iso9717:1990,Phosphate conversion coatings formetals-Method ofspecifying requirements. 3 Dimensions See figure 1 and table 1. Optional end shape at the manufacturer's discretion 1)Radius and dimpled pin end permissible Figure 1 1) To be published. (Revision of ISO.4042:1989) Not for Resale