ISO INTERNATIONAL STANDARD 245 ANSI Internat Doc Sec Secondedition 1998-03-01 Aerospace -- Lockwire Diameters Aéronautigue et espaceFils a freiner-Diametres ISO Referencenumber ISO 245 1998(E) ISO245:1998(E) Foreword Iso (the International Organization for Standardization) is a worldwide federation of national standards bodies (IsO member bodies). The work of preparing International Standards is normally carried out through isO technical committees. Each member body interested in a subject for which a technical committee has been established has the right to be represented on that committee. International organizations, governmental and non- governmental, in liaison with IsO, also take part in the work. IsO collaborates closely with the International Electrotechnical Commission (IEC) on all matters of electrotechnical standardization. Draft International Standards adopted by the technical committees are circulated to the member bodies for voting. Publication as an International a vote. Committee IsO/TC 2o, Aircraft and space vehicles, Subcommittee SC 4, Aerospace fastenersystems. This second edition cancels and replaces the first edition (Is0 245:1986), of which it constitutes a technical revision. @ISO1998 All rights reserved Unless otherwise specified, no part of this publication may be reproduced or utilized in anyform or by any means, electronic or mechanical, including photocopying and microfilm, without permission in writing from the publisher International Organization for Standardization Case postale 56.CH-1211Geneve 20.Switzerland Internet central@isoch X.400 C=ch; a=400net; p=iso, O=isocs; S=central Printed in Switzerland ii 1SO245:1998(E) INTERNATIONALSTANDARD @ISO AerospaceLockwire-Diameters 1 Scope This Internationai Standard specifies the diameters of lockwire. This international Standard is applicable to the compilation of aerospace product standards. 2Configurationanddimensions See figure 1 and table 1. Dimensions and tolerances are expressed in millimetres. Figure 1 Table 1 D nom. tol. 0,5 0,63 ± 0,04 0,8 1 1,25 1,6 ± 0,05 1,8 2