ISO INTERNATIONAL STANDARD 2804 Second edition 1996-12-15 ANSl Internat Doc Sec Wire, bar or tube drawing dies As-sintered pellets of hardmetal (carbide) -- Dimensions Filieres de trefilage et d'eétirage -- Noyaux bruts en carbures métalliques durs-Dimensions ISO Reference number ISO 2804 1996(E) Copyright Intermational Organization for Standardization No reproductic ense from IHS Not for Resale IS02804:1996(E) Foreword IsO (the International Organization for Standardization) is a worldwide federation of national standards bodies (IsO member bodies) The work of preparing International Standards is normally carried out through IsO represented on that committee.International organizations,governmental and non-governmental, in liaison with IsO, also take part in the work isO collaborates closely with the International Electrotechnical Commission (IEC)onall matters of electrotechnical standardization Draft International Standards adopted by the technical committees sare circulated to the member bodies for voting. Publication as an International Standard requires approval by at least 75 % of the member bodies casting avote International Standard ISO 2804 was prepared by Technical Committee ISO/TC 29, Small tools. This second edition cancels and replaces the first edition (IS0 2804.1973), (clause3)of which (designation)hasbeentechnically revised ISO1996 All rights reserved Unless otherwise specified, no part of this publication may be reproduced or utilized in any form or by any means, electronic or mechanical, including photocopying and microfilm, without permission in writing from the publisher International Organization for Standardization CasePostale56.CH-1211Geneve20.Switzerland Printed in Switzerland ii for Standardizatior Not for Resale ISO2804:1996(E) @ISO Introduction The standardization of the dimensions of as sintered pellets has been and drawingdiemanufacturers. The select dimensions will improve the machining conditions of drawing tool manufacturers in order to obtain drawing dies in conformity with ISO1684. 三 Copyriaht intenational Organizatin for Standardizatin No reproduction or networking permitted without license from IHS Not for Resale