ISO INTERNATIONAL STANDARD 3338-3 First edition 1996-12-15 Cylindrical shanks for milling cutters Part 3: Dimensional characteristics of threaded shanks Queues cylindriquesd'outilsa fraiser- Partie 3:Caracteristiques dimensionnelles des queues filetees ISO Referencenumber 1SO 3338-3:1996(E) No Not for Re ISO3338-3:1996(E) Foreword ISO (the International Organization for Standardization) is a worldwide federationof national standards bodies (iSO member bodies).The work technical committees. Each member body interested in a subject for which a technical committee has been established has the right to be represented on that committee.International organizations, govern- mental and non-governmental, in liaison with ISO, also take part in the work. ISO collaborates closely with the International Electrotechnical Commission fIEC) on all matters of electrotechnical standardization. Draft International Standards adopted by the technical committees are bodies casting a vote. International Standard ISO 330-3 was prepared by Technicai Committee ISO/TC29, Smawtools, Subcommittee SC 2,Drills. reamers,milling cutters andmilling machine accessories. ISO 3338 consists of the following parts. under the general title Cylindrical shanks for miling cutters: - Part 1: Dimensional characteristics of plain cylindrical shanks - Part 2: Dimensionaf characteristics of flatted cylindrical shanks 一 Part 3: Dimensiona/ cheracteristics of threaded shanks @ISO1996 All nghts reserved. Unless otherwise specified, no part of this publication may be reproduced or utized in any form or by any means, electronic or mechanical, including photocopying and mcrofilm, without pemission an writing from the publisher, International Organization for Standardization Case Postale 56 • CH-1211 Geneve 20 - Switzrrland Printed in Switzerland Copylignt Irternatioral Organizston for Sandasrdiuason