ISO INTERNATIONAL STANDARD 7176-15 First edition 1996-11-15 Wheelchairs - Part 15: Requirements for information disclosure, documentation and labelling Fauteuilsroulants- Partie 15: Exigences relatives a la diffusion des informations, a la documentation et a I'étiquetage ISO Reference number ISO 7176-15:1996(E) Not for Resale ISO 7176-15:1996(E) Contents Page Scope 1 2 Normative references. 3 Definitions 2 4 Guidance 3 5 Requirements for disclosure of test information in manufacturer's specification sheets 3 6 Test report 3 7 Documentation 3 8 Permanent labelling 5 Annex A Information disclosure in manufacturer's specification sheets ... 9 B Bibliography. 8 @ ISO 1996 All rights reserved. Unless otherwise specified, no part of this publication may be reproduced or utilized in any form or by any means, electronic or mechanicai, including photocopying and microfilm, without permission in writing from the publisher. Internaticnal OrganizationforStandardization Case Postale 56 。CH-1211 Geneve 20 Switzerland Printed in Switzeriand Copyright International Organization for Standardization vided by IHS under Not for Resale ISO 7176-15:1996(E) @ISO Foreword IsO (the International Organization for Standardization) is a worldwide federation of national standards bodies (isO member bodies). The work of preparing International Standards is normally carried out through Iso technicalcommittees.Eachmemberbodyinterestedinasubjectfor which a technical committee has been established has the right to be represented on that committee. International organizations, governmental and non-governmental, in liaison with IsO,also take part in the work.Iso collaborates closely with the International Electrotechnical Commission (IEC) on all matters of electrotechnical standardization. Draft International Standards adopted by the technical committees are International Standards by the Iso' Council. They are approved in accordance with IsO procedures requiring at least 75 % approval by the member bodies voting. International Standard ISO 7176-15 was prepared by Technical Committee IsO/Tc 173, Technical systems and aids for disabled or handicapped persons. Iso 7176 consists of the following parts, under the general title Wheelchairs: Part1:Determinationofstaticstability Part 2: Determination of dynamic stability of electric wheelchairs Part 3: Determination of efficiency of brakes Part 4: Determination of energy consumption of electric wheelchairs and scooters - Theoretical range Part 5: Determination of overall dimensions, mass and turning space Part 6: Determination of maximum speed, acceleration and retardationofelectricwheelchairs Part 7: Measurement of seating and wheel dimensions Part 8: Requirements and test methods for static, impact and fatigue strengths Part 9: Climatic tests for electric wheelchairs Part 10: Determination of obstacle-climbing ability of electric wheelchairs Part 11:Test dummies Part 13: Determination of coefficient of friction of test surfaces Part14:Powerand controlsystems forelectricwheelchairs Reguirementsandtestmethods CopyrightInternational Organization for Standardization ili