ISO INTERNATIONAL STANDARD 90-1 Secondedition 1997-07-01 Light gauge metal containers --- Definitions and determination of dimensions and capacities Part 1: Open-top cans Recipients metalliques legers - Definitions et determination des dimensions et descapacites- Partie 1: Boites serties This material is reproduced from Iso documents under International Organization for Standardization (Iso) Copyright License number IHS/Ic/1996. Not for resale. No part of these ISO documents may be reproduced in any form, electronic retrieval system or otherwise, except as allowed in the copyright law of the country of use, or with the prior written consent of Iso (Case postale 56, 1211 Geneva 20, Switzerland, Fax +41 22 7341079), IHSortheISo Licensor'smembers. ISO Reference number ISO 90-1:1997(E) CopyrightIntemationalOrganizationforStandardization Not for Resale ISO 90-1:1997(E) Contents Page 1 Scope. 1 2 Definitions 1 3 Determination of dimensions . 7 4 Determination of gross lidded capacity, C... 6 5 Tolerances on capacities 11 6 12 Annexes A Measurement of height of open-top cans. 13 B Determination of gross lidded capacity, C (cans filled with 14 C Bibliography ... 17 @1SO1997 All rights reserved. Unless otherwise specified, no part of this publication may be reproduced or utilized in any form or by any means, electronic or mechanical, including photocopying and microfilm, without permission in writing from the publisher. InternationalOrganizationforStandardization Case postale 56 . CH-1211 Geneve 20 . Switzerland Internet [email protected] X.400 C=ch;a=400net;p=iso;0=isocs; S=central Printed in Switzerland ii Copyright International Organization for Standardizatio se from IHS Not for Resa ISO 90-1:1997(E) @ISO Foreword IsO (the International Organization for Standardization) is a worldwide federation of national standards bodies (ISO member bodies). The work of preparing International Standards is normally carried out through IsO technical committees. Each member body interested in a subject for which represented on that committee. International organizations, governmental and non-governmental, in liaison with IsO, also take part in the work. IsO collaborates closely with the International Electrotechnical Commission (lEC)onallmattersofelectrotechnicalstandardization. circulated to the member bodies for voting. Publication as an International Standard requires approval by at least 75 % of the member bodies casting a vote. International Standard ISO 90-1 was prepared by Technical Committee IsO/rC 52, Light gauge metal containers, Subcommittee SC 4, Open-top containers. This second edition cancels and replaces the first edition (IsO 90-1:1986), which has been technically revised. IsO 9o consists of the following parts, under the general title Light gauge metal containers - Definitions and determination of dimensions and capacities: Part 1: Open-top cans Part 2: General use containers Part 3: Aerosol cans Annexes A, B and C of this part of ISO g0 are for information only. ii Copyright Inter No reproduction or networking permitted without license from IHS Not for Resale