ISO INTERNATIONAL STANDARD 9418 First edition 1998-11-15 Aerospace Rivets, solid, in aluminium or aluminium alloys Procurement specification Aéronautique et espace - Rivets ordinaires, en aluminium ou en alliages d'aluminiumSpécification d'approvisionnement ISO Referencenumber ISO 9418:1998(E) yIHS under Not for Resale ISO 9418:1998(E) Contents Page 1Scope 2 Normative references . 3 Terms and definitions 4 Quality assurance 4.1General. 4.1.1 Approval of manufacturers.. 3 4.1.2 Acceptance of solid rivets . 4.2 Acceptance inspection and test conditions..... 4.3 Use of "Statistical process control (SPC)".. 5 Requirements and test methods. 6 Records and test reports .. 11 7 Certificate of compliance 11 ISO1998 All rights reserved. Unless otherwise specified, no part of this publication may be reproduced or utilized in any form or by any means, electronic or mechanical, including photocopying and microfilm, without permission in writing from the publisher. International Organization for Standardization Case postale 56 . CH-1211 Geneve 20 · Switzerland Internet [email protected] Printed in Switzerland Copyright International Organization for Standardization Not for Resale @ ISO ISO 9418:1998(E) Foreword federation of national standards bodies (iSO member bodies). The work of technical committees. Each member body interested in a subject for which atechnicalcommitteehasbeenestablishedhastherighttoberepresented on that committee. International organizations, governmental and non- governmental, in liaison with isO, also take part in the work. isO collaborates closely with the International Electrotechnical Commission (IEC) on all matters of electrotechnical standardization. the ISO/IEC Directives, Part 3. are circulated to the member bodies for voting. Publication as an International Standard requires approval by at least 75 % of the member bodies casting a vote. International Standard iSO 9418 was prepared by Technical Committee fastenersystems. Cropvriatlwtenaional Organiation for tandardizatin ii se from IHS Not for Resale
ISO 9418 1998 Aerospace — Rivets, solid, in aluminium or aluminium alloys — Procurement specification