ISO INTERNATIONAL STANDARD 5747 Secondedition 1995-11-15 Pliers and nippers Lever assisted side cutting pliers, end and diagonal cutting nippers Dimensions and test values Pinces et tenailles - Pinces articulées coupantes de coté, coupantes en bout et coupantes diagonale - Dimensions et valeurs d'essai ISO Referencenumber ISO5747:1995(E) Copyright Intermational Organization for Standardization rovided by IHS mitted without license from IHS Not for Resale ISO5747:1995(E) Foreword ISO (the International Organization for Standardization) is a worldwide federationof national standardsbodies(lsOmemberbodies).Thework represented on that committee. International organizations, governmental and non-governmental, in liaison with IsO, also take part in the work. IsO collaborates closely with the International Electrotechnical Commission (lEC)onallmattersofelectrotechnicalstandardization. are circulated to the member bodies for voting. Publication as an International a vote International Standard ISO 5747 was prepared by Technical Committee ISO/TC 29, Small tools. This second edition cancels and replaces thefirst edition GOS) fication of figure 1 where the opening of the jaws is designated G and the L) and to table 5 (dimension T,). ISO1995 All rights reserved. Unless otherwise specified, no part of this publication may be reproduced or utilized in any form or by any means, electronic or mechanical, including photocopying and microfilm, without permission in writing from the publisher. International Organizationfor Standardization Case Postale 56· CH-1211 Geneve 20· Switzerland Printed in Switzerland := Nor ed without license from IHS Not for Resale INTERNATIONAL STANDARD ISO ISO 5747:1995(E) Pliers and nippers --- Lever assisted side cutting pliers, end and diagonal cutting nippers Dimensions and test values 1Scope This International Standard specifies the principal dimensions of lever assisted side cutting pliers and end and di- agonal cutting nippers, as well as the test values for the pliers and nippers to verify their functioning, according to 1SO 5744. General technical requirements are given in ISO 5743. The lever assisted pliers in this International Standard are only examples and are not intended to affect the manufacturer's design. 2 Normative references Thefollowingstandardscontainprovisionswhich,throughreferenceinthistext,constituteprovisionsofthis International Standard. At the time of publication, the editions indicated were valid. All standards are subject to revision,andpartiestoagreementsbasedonthisInternationalStandardareencouragedtoinvestigatethepossi bilityofapplyingthemostrecenteditionsofthestandardsindicatedbelow.MembersofTECandIsOmaintain registers of currently valid International Standards. Iso 5743:1988, Pliers and nippers General technical requirements. IsO 5744:1988,Pliers and nippers-Methods of test. Copyright International Organization for Standardization Not for Resale