ISO INTERNATIONAL STANDARD 8489-1 Second edition 1995-12-15 Textile machinery and accessories Cones for cross winding Part 1: Recommended main dimensions Materiel pour I'industrie textile -- Cones pour bobinage croisé Partie 1:Dimensions principales recommandées ISO Referencenumber ISO 8489-1:1995(E) No reproduction or networking permitted without license from IHS Not for Resale ISO8489-1:1995(E) Foreword IsO (the International Organization for Standardization) is a worldwide technical committees. Each member body interested in a subject for which a technical committee has been established has the right to be and non-governmental, in liaison with ISO, also take part in the work. isO collaborates closely with the International Electrotechnical Commission (IEC) on all matters of electrotechnical standardization. Draft International Standards adopted by the technical committees are Standard requires approval by at least 75 % of the member bodies casting a vote. International Standard ISO 8489-1 was prepared by Technical Committee committee Sc 2, Winding and preparatory machinery for fabric manufac- ture. This second edition cancels and replaces the first edition (ls08489-1:1985),whichhasbeentechnicallyrevised ISO 8489 consists of the following parts, under the general title Textile machinery and accessories -- Cones for cross winding -Part1:Recommendedmaindimensions Part 2: Dimensions, tolerances and designation of cones with half angle 3 degrees 30° Part 3: Dimensions, tolerances and designation of cones with half angle 4 degrees 20° Part 4: Dimensions, tolerances and designation of cones with half angle 4 degrees 20' for winding for dyeing purposes Part 5: Dimensions, tolerances and designation of cones with half angle5degrees57 @ISO1995 All rights reserved. Unless otherwise specified, no part of this publication may be reproduced microfilm, without permission in writing from the publisher. International Organizationfor Standardization CasePostale56·CH-1211Geneve20·Switzerland Printed in Switzerland nitted withoutlicense from IHS Not fr Resale ISO 8489-1:1995(E) Introduction the abundance of existing types of cones for winding. Their use is srec This part of ISO 8489 is to be considered as the basic standard regarding the main types of cones for future developments. full information on dimensions, tolerances, cone materials, use of gauges and checking of cone lengths. Copyriaht inlenatioal Organizatinfor Standadization ili No reproduction or networking permitted without license from IHS Not for Resale