48519030631837889 INTERNATIONALSTANDARDISO8845:1994 TECHNICALCORRIGENDUM1 ISO Published 1995-09-15 Small craft with inboard engine - Propeller shaft ends and bosses with 1:16 taper TECHNICALCORRIGENDUM 1 Navires de plaisance a moteur interieur-Extremites d'arbres porte-helices et moyeux d'helices avec une conicite de 1:16 RECTIFICATIFTECHNIQUE1 craft. Page3,table1 For propeller shafts of nominal diameter 120 to 160, increase the length of the threaded end length, Ig, by 10 mm, that is: Dnom 3 mm 120 105 130 115 140 115 150 125 160 135 iCS 47.080 Ref.No.SO8845:1994/Cor.1:1995(E) Descriptors: shipbuilding, pleasure boats, marine propellers, propelier shafts, shaft ends, hubs, taper, dimensions, dimensiona! tolerances, designation, interchangeability. CISO1995 Printed in Switzerland Copyright International Organization for Standardization without license from IHS Notfor Resale 4851903 0584315 T27 INTERNATIONAL ISO STANDARD 8845 First edition 1994-12-15 Small craft with inboard engine - Propeller shaft ends and bosses with 1:16 taper Navires de plaisance a moteur interieur -- Extrémités d'arbres porte-helices et moyeux d'helices avec une conicité de 1:16 ISO Reference number ISO 8845:1994(E) Provided by IHS underlicense with Iso ht International Orga Not for Resale 9TEhS0 E E06T5h 963 ISO 8845:1994(E) Foreword IsO (the International Organization for Standardization) is a worldwide federation of national standards bodies (IsO member bodies). The work of preparing International Standards is normally carried out through iso technical committees. Each member body interested in a subject for which a technical committee has been established has the right to be and non-governmental, in liaison with Iso, also take part in the work. isO collaborates closely with the International Electrotechnical Commission (lEC) on all matters of electrotechnical standardization. circulated to the member bodies for voting. Publication as an International Standard requires approval by at least 75 % of the member bodies casting a vote. International Standard SO 8845 was prepared by Technical Committee ISO/TC 188, Small craft. Annex A of this International Standard is for information only. ISO 1994 All rights reserved. Unless otherwise specified, no part of this publication may be reproduced or utilized in any form or by any means, electronic or mechanical, including photocopying and microfilm, without permission in writing from the publisher. International Organization for Standardization Case Postale 56· CH-1211 Geneve 20· Switzerland Printed in Switzerland No reproduction tworking permitted without license from IHS Not for Resale