ISO INTERNATIONAL STANDARD 105-F10 First edition 1989-12-01 Textiles -- Tests for colour fastness Part F10 : Specification for adjacent fabric: Multifibre Textiles-Essaisdesoliditedesteintures-- Partie F10:Specification pour le tissutemoin:Multifibre Referencenumber ISO 105-F10:1989(E) v/9976803100 No reproduction or networking permitted without license from IHS ISO105-F10:1989(E) Foreword Iso (the International Organization for Standardization) is a worldwide federationofnationalstandardsbodies(isOmemberbodies).Thework of preparing International Standards is normally carried out through iso technical committees.Each memberbodyinterested in a subject for which a technical committee has been established has the right to be represented on that committee. International organizations, govern- mental and non-governmental, in liaison with iso, also take part in the work. Iso collaborates closely with the International Electrotechnical Commission (IEC) on all matters of electrotechnical standardization. Draft International Standards adopted by the technical committees are circulated to the member bodies for approval before their acceptance as International Standards by the iso Council. They are approved in member bodies voting. International Standard iso 105-F10 was prepared by Technical Commit- tee ISO/TC 38, Textiles. Iso 105 was previously published in 13"parts", each designated by a Each part contained a series of "sections", each designated by the re- spective'part letter and by atwo-digit serial number (e.g. "Section Ao1"). These sections are now being republished as separate documents,themselves designated"parts”butretaining theirearlier alphanumeric designations. A complete list of these parts is given in ISO105-A01. AnnexAformsan integral partofthispartofIso.105. CISO1989 All rights reserved. No part of this publication may be reproduced or utilized in any form permission in writing from the publisher. International Organization for Standardization Case Postale 56: CH-1211 Geneve 20· Switzerland Printed in Switzerland ii onalOrganization for Standardization i/9976803100 No reproduction or networking permitted without license from IHS Not for Resale, 08/06/2005 02:40:39 MDT ISO 105-F10:1989(E) INTERNATIONAL STANDARD Textiles Testsfor colourfastness Part F10 : Specification for adjacent fabric: Multifibre 1 Scope IsO105-J02:1987,Textiles-Testsfor colourfastness -PartJo2:Methodfortheinstrumentalassessment This part of so 105 establishes general require- ofwhiteness. ments for undyed multifibre adjacent fabrics which may be usedfortheassessment of staining in colour 3 General requirements fastness test procedures. The multifibre adjacent fabrics exhibit standardized staining properties. 3.1 Each component of the multifibre adjacent fab- 2 Normative references ric shall be made from fibres having staining char- acteristics similartothose usedin the The following standards contain provisions which, corresponding single-fibre adjacent fabrics specified through reference in this text, constitute provisions in ISO 105-F:1985, sections F01 to F05, F07 and F08 of this part of iso 105. At the time of publication, the The staining characteristics of multifibre adjacent editions indicated were valid. All standards are fabrics shall be determined using the method in an- subject to revision, and parties to agreements based nex A. on this partof iso 105 are encouraged to investigate the possibility of applying the most recent editions 3.2 There are two types of multifibre adjacent fab- of the standards indicated below.Members of IEC ric as described in table 1. and iso maintain registers of currently valid Inter- national Standards. Table 1 一 Muitifibre adjacent fabrics Iso105-A01:1989,Textiles-Testsforcolourfast- Multifibre DW Multifibre TV ness - Part Ao1: General principles of testing. Secondary acetate Triacetate Iso:105-A02:1987,Textiles --Tests for colour fast- Bleached cotton Bleached cotton ness -Part Ao2: Grey scale for assessing ch