ISO INTERNATIONAL STANDARD 1465 Second edition 1989-09-15 Aircraft -- Liquid oxygen replenishment couplings - Mating dimensions Aeronefs - Raccords de remplissage en oxygene liquide - Dimensions de raccordement Referencenumber ISO 1465 : 1989 (E) No reproduction or networking permitted without license from IHS Not for Resale ISO 1465 :1989 (E) Foreword Iso (the International Organization for Standardization) is a worldwide federation of national standards bodies (Iso member bodies). The work of preparing International Standards is normally carried out through IsO technical committees. Each member body interested in a subject for which a technical committee has been established has the right to be represented on that committee. International organizations, govern- mental and non-governmental, in liaison with ISO, also take part in the work. ISO collaborates closely with the International Electrotechnical Commission (IEC) on all matters of electrotechnical standardization. the member bodies for approval before their acceptance as International Standards by the Iso Council. They are approved in accordance with iSO procedures requiring at least 75 % approval by the member bodies voting. International Standard ISO 1465 was prepared by Technical Committee ISO/TC 20, Aircraftandspacevehicles. This second edition cancels and replaces the first edition (Iso 1465 : 1976), of which it constitutes a minor revision. ? ISO1989 Ail rights reserved. No part of this publication may be reproduced or utilized in any form or by any means, electronic or mechanical, including photocopying and microfilm, without permission in writing from the publisher. International OrganizationforStandardization Case postale 56 . CH-1211 Geneve 20 . Switzerland Printed in Switzerland No reproduction or networking permitted without license from IHS Not for Resale ISO1465:1989(E) INTERNATIONAL STANDARD Aircraft t - Liquid oxygen replenishment couplings Mating dimensions Scope 2.2 The aircraft half of the replenishment coupling for liquid oxygen shall mate with the ground half replenishment coupling. This International Standard specifies the mating and clearance 3 Clearance envelope 2 Interchangeability The clearance envelope in the aircraft to accommodate the 2.1 The mating dimensions and characteristics of the ground ground half of the replenishment coupling, for the purposes of half of the liquid oxygen replenishment coupling shall conform coupling and uncoupling the hose unit, shall be in accordance to those in figure 1 and table 1. with figure 2 and table 2. 1 No reproduction or networking permitted without license from IHS Not for Resale