ISO INTERNATIONAL STANDARD 3002-5 First edition 1989-11-01 Basic quantities in cutting and grinding - Part 5 : Basic terminology for grinding processes using grinding wheels Grandeurs de base en usinage et rectification - Partie 5 : Terminologie de base propre au meulage Reference number ISO 3002-5 : 1989 (E) Copyright Intermational Organization for Standardization Provided by IHS cense with Is ermitted without license from IHS Not for Resale ISO 3002-5 : 1989 (E) Foreword Iso (the International Organization for Standardization) is a worldwide federation of national standards bodies (isO member bodies). The work of preparing International Standards is normally carried out through Iso technical committees. Each member body interested in a subject for which a technical committee has been established has the right to be represented on that committee. International organizations, govern- mental and non-governmental, in liaison with Iso, also take part in the work. isO collaborates closely with the International Electrotechnical Commission (IEC) on all matters of electrotechnical standardization. Draft International Standards adopted by the technical committees are circulated to the member bodies for approval before their acceptance as International Standards by the Iso Council. They are approved in accordance with ISO procedures requiring at International Standard ISO 3002-5 was prepared by Technical Committee ISO/TC 29, Small tools. ISo 3002 will consist of the following parts, under the general title Basic quantities in cutting and grinding : Part 1: Geometry of the active part of cutting tools - General terms, reference systems, tool and working angles, chip breakers Part 2: Geometry of the active part of cutting tools - General conversion for- mulae to relate tool and working angles Part 3: Geometric and kinematic quantities in cutting Part 4:Forces,energy,power Part 5: Basic terminology for grinding processes using grinding wheels Part 6: Quantity as a function of time Annex A of this part of ISO 3002 is for information only ISO 1989 All rights reserved. No part of this publication may be reproduced or utilized in any form or by any means, electronic or mechanical, including photocopying and microfilm, without permission in writing from the publisher. International Organization for Standardization Case postale 56 . CH-1211 Geneve 20 . Switzerland Printed in Switzerland ii Copyright Intermational Organizatinfor Standadization No reproduction o Dermited without license from IHS Not for Resale INTERNATIONAL STANDARD ISO 3002-5 : 1989 (E) Basic quantities in cutting and grinding Part 5 : Basic terminology for grinding processes using grinding wheels 1 Scope ISo 841 : 1974, Numerical control of machines - Axis and mo- tion nomenclature. The aim of this part of isO 3002 is to apply the basic ter- minology defined in ISo 3002, parts 1 to 4, specifically to grind- Is0 3002-1 : 1982, Basic quantities in cutting and grinding ing operations and to define additional quantities specific to Part 1: Geometry of the active part of cutting tools General grinding. terms, reference systems, tool and working angles, chip breakers. NOTE - In addition to terms used in the three official ISO languages (English, French and Russian), this part of iSo 3002 gives the IS0 3002-2 : 1982, Basic quantities in cutting and grinding equivalent terms in the German, Italian and Dutch languages; these are Part 2: Geometry of the active part of cutting tools -General published under the responsibility of the member bodies for Germany, conversion formulae to relate tool and working angles. F.R. (DIN), Italy (UNI), the Netherlands (NNI) and Belgium (IBN). However, only the terms given in the official languages can be con- IS0 3002-3 : 1984, Basic quantities in cutting and grinding sidered as ISO terms. Part 3: Geometric and kinematic quantities in cutting. For the purposes of this part of ISO 3002 the meaning of the IS0 3002-4 : 1984, Basic quantities in cutting an