ISO 3774 INTERNATIONAL STANDARD Third edition 1988-11-01 INTERNATIONAL ORGANIZATION FOR STANDARDIZATION so ORGANISATION INTERNATIONALE DE NORMALISATION MEXKAYHAPOAHAA OPIAHM3ALMA NO CTAHAAPTW3AMM Cinematography - 35 mm motion-picture film perforated 8 mm Type S (1-3-5-7-0) and (1-0) - Cutting and perforating dimensions Cinematographie - Film cinematographique 35 mm perforé 8 mm, type S (1-3-5-7-0) et(1-O)-Dimensions decoupeet deperforation Reference number ISO 3774 : 1988 (E) ted without license from IHS Not for Resale ISO 3774 : 1988 (E) Foreword Iso (the International Organization for Standardization) is a worldwide federation of national standards bodies (Iso member bodies). The work of preparing International Standards is normally carried out through ISO technical committees. Each member body interested in a subject for which a technical committee has been established has mental and non-governmental, in liaison with ISO, also take part in the work. ISO collaborates closely with the International Electrotechnical Commission (IEC) on all matters of electrotechnical standardization. Draft International Standards adopted by the technical committees are circulated to the member bodies for approval before their acceptance as International Standards by the ISO Council. They are approved in accordance with ISO procedures requiring at least 75 % approval by the member bodies voting. International Standard ISO 3774 was prepared by Technical Committee ISO/TC 36, Cinematography. This third edition cancels and replaces the second edition (ISO 3774 : 1982), of which it constitutes a minor revision, the annex having been replaced. Users should note that all International Standards undergo revision from time to time and that any reference made herein to any other International Standard implies its latest edition, unless otherwise stated. @ International Organization for Standardization, 1988 Printed in Switzerland ted without license from IHS Not for Resale INTERNATIONAL STANDARD ISO 3774 : 1988 (E) Cinematography -- 35 mm motion-picture film perforated 8 mm Type S (1-3-5-7-0) and (1-0) - Cutting and perforating dimensions Scope and field of application Dimensions 3 This International Standard specifies the cutting and per- The dimensions and tolerances shall be as shown in the figures forating dimensions for 35 mm motion-picture raw stock either and given in the table. They apply to safety raw stock, as with five rows of perforations in positions 1-3-5-7-0 or with two described in ISo 543. Except for dimensions A' and E1, they rows of perforations in positions 1-0, as well as the width of the 8 mm strip after processing and slitting the print stock. required by usage, the manufacturer should indicate the atmospheric conditions applied to dimensional control at the time of cutting and perforating. Reference ISO 543, Cinematography - Motion-picture safety film - Definition, testing and marking. Copyright International Organization for Standardization Not for Resale d without license from IHS