5417 International Standard OSI) INTERNATIONALORGANIZATIONFOR STANDARDIZATION+MEKAYHAPOAHAOPrAHW3AMHNO CTAHAAPTW3ALWM+ORGANISATION INTERNATIONALEDENORMALISATION ANST Refractory bricks for use in rotary kilns -- Dimensions Briques refractairesautiliserdansles fours rotatifs-Dimensions First edition - 1986-11-15 UDC 666.76-43 ISO 5417-1986 (E) Ref. No. 1SO 5417-1986 (E) Descriptors : kilns, refractory materials, bricks, dimensions. Price based on 2 pages CopyrightInternationalOrganizationforStandardization No reproduction or networking permitted without license from IHS Not for Resale Foreword Iso (the International Organization for Standardization) is a worldwide federation of national standards bodies (iso member bodies). The work of preparing International Standards is normally carried out through Iso technical committees. Each member bodyinterested ina subjectforwhichatechnical committeehasbeen establishedhas the right to be represented on that committee. International organizations, govern- mental and non-governmental, in liaison with iso, also take part in the work. Draft International Standards adopted by the technical committees are circulated to the member bodies for approval before their acceptance as International Standards by the ISo Council. They are approved in accordance with IsO procedures requiring at International Standard ISO 5417 was prepared by Technical Committee ISO/TC 33, Refractories. Users should note that all International Standards undergo revision from time to time and that any reference made herein to any other International Standard implies its latest edition, unless otherwise stated. International OrganizationforStandardization,1986 Printed in Switzerland CopyrightInternational Organization for Standardization No reproduction or networking permitted without license from IHS Not for Resale ISO 5417-1986 (E) INTERNATIONAL STANDARD Refractory bricks for use in rotary kilns -- Dimensions 0 Introduction Dimensions Inpreparingthisinternational Standard,anattempthasbeen The dimensions of basic, fireclay and high alumina refractory madeto reducethenumberofbrickdimensionsbelowthoseat bricks for use in rotary kilns shall be as shown in tables 1 and 2 presentbeing used. If a longer brick is required, the use of a brick with length L of 250 mm is strongly recommended. 1 Scope and field of application It is recognized that bricks having a cold face dimension A of 90 mm are still used in certain countries. This International Standard specifies a range of dimensions of basic, fireclay and high alumina refractory bricks for use in rotary kilns. Tolerances It does not apply to special closure bricks for use in completing Tolerances on the dimensions shall be the subject of agreement circles. between the purchaser and the supplier. NOTE -- A standard system of hot-face identification marking is in NOTE -- Experience has shown that, in the lining of rotary kilns, the course of preparation. tolerance on the length L is of particular importance. Provided by IHS under license with ISO No reproduction or networking permited without