150571390 485190300959925 INTERNATIONAL ISO STANDARD 5713 First edition 1990-10-01 Equipment for working the soil -- Fixing bolts for soil working elements Materiel de travail du sol --- Boulons pourla fixation des pieces d'usure Referencenumber ISO 5713:1990(E) 150571390 4851903 0095993 7 ISO5713:1990(E) Foreword ISO(theInternationalOrganizationforStandardization)isaworldwide federation of national standards bodies (iso member bodies).The work of preparing International Standards is normally carried out through iso technical committees.Eachmember bodyinterested in asubject for whichatechnical committeehasbeenestablished hasthe right'tobe represented on that committee. International organizations, govern- mental and non-governmental, in liaison with iso, also take part in the work. Iso coliaborates closely with the International Electrotechnical Commission(lEC)onallmattersofelectrotechnicalstandardization. DraftInternational Standards adopted bythetechnical committeesare circulatedtothe memberbodiesfor voting.PublicationasanInterna- tional Standard requires approval by at least 75% of themember bodies castinga vote. InternationalStandardIso5713waspreparedbyTechnicalCommittee iso/Tc 23,Tractorsand machinery for agriculture and forestry. ?ISO1990 All rlghts reserved.No part of this publication may be reproduced or utilized in any form or by any means, electronic or mechanical, including photocopying and microfllm, without permlssioninwritingfromthepublisher. InternationalOrganizationforStandardization CasePostale56·CH-1211Geneve20·Switzerland Printed In Switzerland ii 485190300959949 IS571390 INTERNATIONAL STANDARD ISO5713:1990(E) Equipment for working the soil - Fixing bolts for soil working elements 1 Scope Iso898-1:1988,Mechanical properties of fasteners -Part1:Bolts,screwsandstuds. This International Standard specifies dimensions and characteristics of three types of bolts forthe Iso965-3:1980,1sogeneralpurposemetric screw fixingof soil workingelements. threads -Tolerances -- Part3:Deviations for constructional threads. 2 Normative references Iso4759-1:1978,Tolerancesfor fasteners---Part1: Bolts, screws and nuts with thread diameters be- The foliowing standards contain provisions which through reference in this text, constitute provisions tween 1,6 (inclusive) and 150 mm (inclusive) and product grades A, B and C. ofthisInternationalStandard.Atthetimeofpubli- cation,the editions indicated were valid.All stan- dards are subject to revision, and parties to agreements based on this International Standard are encouraged to investigate the possibility of ap- 3 Dimensions plying the most recent editions of the standards in- dicatedbelow.MembersofIECandIsOmaintain Bolt dimensions are shown infigure1,figure2and registers of currently valid International Standards. figure3,andgivenintable1,table2andtable3.