ISO 5822 INTERNATIONAL STANDARD Second edition 1988-12-01 INTERNATIONAL ORGANIZATION FOR STANDARDIZATION ORGANISATION INTERNATIONALE DE NORMALISATION MEXKAYHAPOAHAA OPIAHW3ALMA NO CTAHAAPTM3ALMM Spot welding equipment - Taper plug gauges and taper ring gauges Materiel de soudage par points - Calibres coniques males et calibres coniques femelles Reference number ISO 5822 : 1988 (E) Copyright International Organization for Standardization tted without license from IHS Not for Resale ISO 5822 : 1988 (E) Foreword Iso (the International Organization for Standardization) is a worldwide federation of national standards bodies (ISO member bodies). The work of preparing International Standards is normally carried out through isO technical committees. Each member body interested in a subject for which a technical committee has been established has the right to be represented on that committee. International organizations, govern- mental and non-governmental, in liaison with ISO, also take part in the work. ISO collaborates closely with the International Electrotechnical Commission (IEC) on all matters of electrotechnical standardization. Draft International Standards adopted by the technical committees are circulated to the member bodies for approval before their acceptance as International Standards by the ISo Council. They are approved in accordance with ISO procedures requiring at least 75 % approval by the member bodies voting. International Standard ISO 5822 was prepared by Technical Committee ISO/TC 44, Welding and allied processes. This second edition cancels and replaces the first edition (IS0 5822 : 1982), clause 4 of which has been technically revised. International Organization for Standardization, 1988 Printed in Switzerland Copyright International Organization for Standardization tworking permited without license from IHS Not for Resale INTERNATIONAL STANDARD ISO 5822 : 1988 (E) Spot welding equipment -- Taper plug gauges and taper ring gauges ISO 1302 : 1978, Technical drawings - Scope - Method of indicating surface texture on drawings. This International Standard specifies requirements for taper plug and ring gauges used for the checking of type A, B and C Iso 1947 : 1973, System of cone tolerances for conical tapers according to ISO 1089. workpieces from C = 1 : 3 to 1 : 500 and lengths from 6 to 630 mm. 2 Normative references iSO 3670 : 1979, Blanks for plug gauges and handles (taper lock and trilock) and ring gauges -- Design and general dimensions. The following standards contain provisions which, through reference in this text, constitute provisions of this International Standard. At the time of publication, the editions indicated 3 Definitions were valid. All standards are subject to revision, and parties to agreements based on this International Standard are encour- 3.1 type A tapers: Type A tapers are those suitable for aged to investigate the possibility of applying the most recent editions of the standards listed below. Members of IEC and ISO straight thrust. maintain registers of currently valid tnternational Standards. 3.2 type B tapers: Type B tapers are those suitable for ISO 286-1 : 1988, /SO system of limits and fits - Part 1: Bases eccentric loading. of tolerances, deviations and fits. ISo 1089 : 1980, Electrode taper fits for spot welding equip- 3.3 type C tapers: Type C tapers are those suitable for elec- ment - Dimensions. trode caps. 1 Copyright International Organization for Standardization Not for Resale ense from IHS