ISO INTERNATIONAL STANDARD 9242 First edition 1988-07-15 INTERNATIONAL ORGANIZATION FOR STANDARDIZATION ORGANISATION INTERNATIONALE DE NORMALISATION MEXKAYHAPOAHAR OPrAHM3ALMH HO CTAHAAPTM3ALMM Pliers and nippers -- Construction worker's pincers - Dimensions and test values Pinces et tenailles - Tenailles de macon - Dimensions et valeurs d'essai Referencenumber ISO 9242: 1988 (E) Copyright Intermational Organization for Standardization nitted without license from IHS Not for Resale ISO 9242 : 1988 (E) Foreword ISo (the International Organization for Standardization) is a worldwide federation of national standards bodies (ISO member bodies). The work of preparing International Standards is normally carried out through ISO technical committees. Each member body interested in a subject for which a technical committee has been established has the right to be represented on that committee. International organizations, govern- mental and non-governmental, in liaison with ISO, also take part in the work. ISO collaborates closely with the International Electrotechnical Commission (IEC) on all matters of electrotechnical standardization. Draft International Standards adopted by the technical committees are circulated to the member bodies for approval before their acceptance as International Standards by the Iso Council. They are approved in accordance with ISO procedures requiring at International Standard ISO 9242 was prepared by Technical Committee ISO/TC 29, Small tools. International OrganizationforStandardization,1988 Printed in Switzerland Copyright Intemational Oorganizatin for Standardization No reprodt Not for Resale INTERNATIONAL STANDARD ISO 9242 : 1988 (E) Pliers and nippers - Construction worker's pincers Dimensions and test values 1 Scope were valid. All standards are subject to revision, and parties to agreements based on this International Standard are encouraged This International Standard specifies the principal dimensions to investigate the possibility of applying the most recent of constructionworker'spincersand thetestvalues inorderto editions of the standards listed below. Members of IEC and ISO verify their aptitude to function in conformity with ISO 5744. maintain registers of currently valid International Standards. The general technical requirements are given in ISO 5743 ISo 5743:1982,Pliers and nippers General technical The construction worker's pincers illustrated in this Inter- requirements. national Standard are only examples and are not intended to affect the manufacturers' design. ISo 5744 : 1988, Pliers and nippers - Methods of test. 2 Normative references 3 Dimensions and test values The following standards contain provisions which, through reference in this text, constitute provisions of this International Standard.At the time of publication,the editions indicated 3.1 Construction worker's pincers - Style A w1=45±5 mm F(F) Y L1 L2 F(F,) 7 Figure 1 Copyright Intermational Organization for Standardization ermitted without license from IHS Not for Resale