ISO INTERNATIONAL STANDARD 9374-1 First edition 1989-11-15 Cranes --- Information to be provided Part 1 : General Appareils de levage a charge suspendue -- Informations a fournir - Partie 1: Géneralités Referencenumber iSO 9374-1:1989(E) ISO 9374-1:1989(E) Foreword Iso (the International Organization for Standardization) is a worldwide federation of national standards bodies (IsO member bodies). The work of preparing International Standards is normally carried out through Iso technical committees. Each member body interested in a subject for which a technical committee has been established has the right to be represented on that committee. International organizations, govern- mental and non-governmental, in liaison with isO, also take part in the work. isO collaborates closely with the International Electrotechnical Commission(lEC)onallmattersofelectrotechnicalstandardization Draft International Standards adopted by the technical committees are circulated to the member bodies for approval before their acceptance member bodies voting international Standard iso 9374-1 was prepared by Technical Committee ISO/TC 96, Cranes. Iso 9374 consists of the following parts, under the e general title Cranes --- Information tobeprovided: Part 1: General Part 2:Mobile cranes -Part3:Tower cranes - Part 4: Jib cranes -- Part 5: Overhead travelling cranes and portal bridge cranes C ISO 1989 All rights reserved. No part of this publication may be reproduced or utilized in any form or by any means, electronic or mechanical, including photocopying and microfilm, without permission in writing from the publisher. International Organizationfor Standardization Case Postale 56CH-1211 Geneve 20·Switzerland Printed In Switzerland ii ISO 9374-1:1989(E) INTERNATIONAL STANDARD Cranes -- Information to be provided - Part 1 : General 1 Scope b) sufficient information to enable the classification of the crane as a whole and for each mechanism to be established in accordance with isO 4301-1; mation to be provided by the purchaser and the manufacturer so that the most suitable crane can be c) details of where the crane is to be used or in provided for the duty requirements and service stalled with details of any special or hazardous conditions that may apply; conditions. d) details of load(s) to be lifted and lifting 2 Normative references attachment(s), jib or tower configurations, oper. ating speeds and height of lift and any other op. The following standards contain provisions which, eratingrequirements thatcome withinthe through reference in this text, constitute provisions variations that are obtainable for the type of of this part of iso 9374. At the time of publication crane concerned; the editions indicated were valid. All standards are subject to revision, and parties to agreements based e) any dimensional or clearance restrictions; on this part of isO 9374 are encouraged to investi- gate the possibility of applying the most recent edi- any other special requirements of the purchaser. tions of the standards indicated below. Members of IEC and IsO maintain registers of currently valid 4 Information to be provided by International Standards. manufacturer IsO 4301-1:1986, Cranes and lifting gappliances Classification-Part 1:General The information to be provided by the manufacturer shall include, as appropriate for the type of crane ISO7363:1986, Cranes and lifting appliances concerned: Technical characteristics and acceptance documents. a) technical information and test certificates for the crane to facilitate its installation and/or use in Information to be provided by purchaser accordance with iso 7363; 3 with enquiry or order b) an instruction manual which shalt include details of routine servicing,inspection and maintenance The information to be provided by the purchaser ofthe crane; shall include, as appropriate for the type of crane concerned: c) dimensions, masses and any other details a) the identity of the parties concerned with ad- dresses, tel