2924 NTERNATIONAL STANDARD Tso) INTERNATIONAL ORGANIZATION FOR STANDARDIZATION MEXIyHAPOIHA OPTAHW3ALMS HIO CTAHIAPTH3ALIWH.ORGANISATION INTERNATIONALE DE NORMALISATION Solid and segmental circular saws for cold cutting of metals -- Interchangeability dimensions of the drive -- Saw diameter range 224 to 2 240 mm First edition - 1973.-12-01 ISO 2924-1973 (E) UDC 621.934 Ref. No. ISO 2924-1973 (E) Descriptors : tools, saws, circular saws, drives, dimensions, interchangeability. Price based on 2 pages Not for Resale FOREWORD IsO (the International Organization for Standardization) is a worldwide federation of national standards institutes (ISO Member Bodies). The work of developing International Standards is carried out through iSO Technical Committees. Every governmental and non-governmental, in liaison with isO, also take part in the work. Draft International Standards adopted by the Technical Committees are circulated to the Member Bodies for approval before their acceptance as Internationa Standards by the ISO Counci. ISO 2924 was drawn up by Technical Committee International Standard ISO/TC 29, Small tools, and circulated to the Member Bodies in October 1972. It has been approved by the Member Bodies of the following countries : Austria India Thailand Belgium Israel Turkey Italy Czechoslovakia United Kingdom France Romania U.S.S.R. Germany South Africa, Rep. of Hungary Switzerland No Member Body expressed disapproval of the document. @ International Organization for Standardization, 1973 : Printed in Switzerland No fr Resale No reproduction or networking permited without license from IHS INTERNATIONAL STANDARD ISO 2924-1973 (E) Solid and segmental circular saws for cold cutting of metals Interchangeability dimensions of the drive -- Saw diameter range 224 to 2 240 mm 1 SCOPE AND FIELD OF APPLICATION This International Standard specifies the interchangeability dimensions of the drive of saws for cold cutting of metals. segments. 2 REFERENCES ISO/R 240, Interchangeability dimensions for milling cutters and cutter arbors or cutter mandrels - Metric series and inch series. ISO/R 523, Recommended range of outside diameters for milling cutters. ISO/R 1101, Tolerances of form and of position -- Part I : Generalities, symbols, indications on drawings. 3 INTERCHANGEABILITY the R 20 series of preferred numbers and that of the diameters recommended in the R 10 series, in compliance with ISO/R523. The range of internal diameters d is taken from iSO/R 240, with the addition of internal diameter 120 mm. Not for Resale