6537 (ISO International Standard INTERNATIONAL ORGANIZATION FOR STANDARDIZATION MEXAYHAPOAHAA OPrAHW3AUMA HO CTAHAAPTW3AUWW-ORGANISATION INTE RNATIONALE DE NORMALISATION Pneumatic fluid power systems - Cylinder barrels Requirements for non-ferrous metallic tubes Transmissions pneumatiques -- Tubes pour verins - .Caracteristiques des tubes enmetauxnon ferreux First edition -- 1982-12-01 UDC 621.226 : 62-462 : 669.35 + .71 Ref. No. ISO 6537-1982 (E) SO 6537-1982 (E) Descriptors : pneumatic fluid power, pneumatic cylinders, pipes (tubes), metal tubes, non-ferrous products, dimensions, dimensional tolerances, mechanical properties, surface condition, delivery conditions. Price based on 6 pages from IHS Not for Resale Foreword ISo (the International Organization for Standardization) is a worldwide federation of national standards institutes (isoO member bodies). The work of developing Inter- national Standards is carried out through ISO technical committees. Every member body interested in a subject for which a technical committee has been set up has the right to be represented on that committee. tnternational organizations, governmental and non-governmental, in liaison with Iso, also take part in the work. Draft International Standards adopted by the technical committees are circulated to the member bodies for approval before their acceptance as International Standards by the ISO Council. International Standard iSO 6537 was deveioped by Technical Committee ISO/TC 131, Fluid power systems, and was circulated to the member bodies in September 1981. It has been approved by the member bodies of the following countries : Hungary Australia South Africa, Rep. of Austria India Sweden Belgium treland Switzerland Canada Mexico United Kingdom China Netherlands USA Norway USSR Egypt, Arab Rep. of Finland Poland Germany, F.R. Romania The member bodies of the following countries expressed disapproval of the document on technical grounds : France Japan @ International Organization for Standardization, 1982 Printed in Switzerland Copyright International Organization for Standardization NotforResa Contents Page Introduction Scope and field of application . References 3 Definitions 4Symbols Manufacture of base tubes Pressures Temperature 7 Tolerances 9 Surface finish 10 Protection and packing 11 Test certification 12 Identification statement Annexes Non-ferrous metallic pneumatic cylinder tube dimensions and tolerances . . A Method of ordering . ili Copyright International Organization for Standardization Not for Resale