(ISo International Standard 7436 Slotted set screws with cup point Vis sans tete, fendues, a bout cuvette First edition -- 1983-09-01 UDC 621.882.219.4.092.6 (ISO 7436-1983 (E) Ref. No. 1SO 7436-1983 (E) Descriptors : fasteners, screws, slotted headless screws, dimensions, specifications, designation. Price based on 3 pages Not for Resal Foreword national standards bodies (IsO member bodies). The work of developing International Standards is carried out through ISo technical committees. Every member body interested in a subject for which a technical committee has been authorized has the and non-governmental, in liaison with IsO, also take part in the work Draft International Standards adopted by the technical committees are circulated to the member bodies for approval before their acceptance as International Standards by the ISO Council. International Standard ISO 7436 was developed by Technical Committee ISO/TC 2, Fasteners, and was circulated to the member bodies in December 1981. It has been approved by the member bodies of the following countries : Hungary Poland Austria Belgium India Romania Brazil Ireland South Africa, Rep. of China Japan Spain Czechoslovakia Korea, Dem. P. Rep. of Sri Lanka Denmark Korea, Rep. of Sweden Egypt, Arab Rep. of Mexico Switzerland Finland Netherlands United Kingdom New Zealand USSR France Norway Germany, F.R. No member body expressed disapproval of the document. @ International Organization for Standardization, 1983 Printed in Switzerland Copyright International Organization for Standardization ISO 7436-1983 (E) INTERNATIONAL STANDARD Slotted set screws with cup point Scope and field of application This International Standard specifies the characteristics of slotted set screws with cup point and thread sizes from M 1,6 to M 12 inclusive and product grade A. If other specifications are required, it is recommended that they should be selected from existing International Standards, for example ISO 261, IsO 888, ISO 898, ISO 965, ISO 3506, isO 4759/1. 2 References Iso 225, Fasteners - Bolts, screws, studs and nuts - Symbols and designations of dimensions. Iso 261, /SO general purpose metric screw threads - General plan. Iso 888, Bolts, screws and studs - Nominal lengths, and thread lengths for general purpose bolts. iso 898, Mechanical properties of fasteners. Iso 965, IsO general purpose metric screw threads - Tolerances. IsO 3269, Fasteners - Acceptance inspection.1) ISo 3506, Corrosion-resistant stainless steel fasteners - Specifications. Iso 4042, Threaded components -- Electroplated coatings components.1) ISO 4753, Fasteners - Ends of parts with external metric /SO thread. Iso 4759/1, Tolerances for fasteners - Part 1: Bolts, screws and nuts with thread diameters ≥ 1,6 and < 150 mm and product grades A, B and C. 1) At present at the stage of draft. Copyright International Organization for Standardization e from IHS Not for Resale