ISO INTERNATIONAL STANDARD 8525 First edition 2008-06-15 Airborne noise emitted by machine tools Operating conditions for metal-cutting machines Bruit aérien émis par les machines-outils - Conditions de fonctionnement des machines travaillant par enlevement de metal Reference number ISO 8525:2008(E) @ ISO 2008 by IHS under lic Not for Resale ISO8525:2008(E) PDF disclaimer This PDF file may contain embedded typefaces. In accordance with Adobe's licensing policy, this file may be printed or viewed but shall not be edited unless the typefaces which are embedded are licensed to and installed on the computer performing the editing. In downloading this file, parties accept therein the responsibility of not infringing Adobe's licensing policy. The IsO Central Secretariat accepts no liability in this area. Adobe is a trademark of Adobe Systems Incorporated. Details of the software products used to create this PDF file can be found in the General Info relative to the file; the PDF-creation parameters were optimized for printing. Every care has been taken to ensure that the file is suitable for use by IsO member bodies. In the unlikely event that a problem relating to it is found, please inform the Central Secretariat at the address given below. COPYRIGHT PROTECTED DOCUMENT @ISO2008 All rights reserved. Unless otherwise specified, no part of this publication may be reproduced or utilized in any form or by any means, electronic or mechanical, including photocopying and microfilm, without permission in writing from either IsO at the address below or IsO's member body in the country of the requester. ISO copyright office Case postale 56 . CH-1211 Geneva 20 Tel. + 41 22 749 01 11 Fax + 41 22 749 09 47 E-mail [email protected] Web www.iso.org Published in Switzerland @ IS0 2008 - All rights reserved py IHS unde I without license from IHS Not for Resale ISO 8525:2008(E) Contents Page Foreword 1 Scope 2 Normative references 3 Terms and definitions. 4 Preliminary remarks .. 4.1 Reference to ISo 230-5 and other standards. 4.2 Tests to be performed .... 5 Installation and mounting conditions.. 5.1 General...... 5.2 Machine installation.. 5.3 Microphone positions... 6 Operating conditions. 7 Measurement uncertainty .. 8 Information to be recorded.. 9 Information to be reported.. 10 Declaration and verification of noise-emission values Annex A (normative) Operating conditions for turning machines... 6 Annex B (normative) Operating conditions for milling machines . .10 Annex C (informative) Data sheets for noise-emission measurement of turning machines... .15 Annex D (informative) Data sheets for noise-emission measurement of milling machines .. 20 Bibliography. 25 CopyrightInternational Oganizainfrsandardizalinghts reserved ii se from IHS Not for Resale