ISO INTERNATIONAL STANDARD 10958-1 First edition 1998-06-15 Snowboards Binding mounting area - Part 1: Requirements and test methods for snowboards without inserts Surfs des neiges - Zone de montage de la fixation - Partie 1: Exigences et meéthodes d'essai relatives aux surfs des neiges depourvusd'inserts ISO Reference number ISO 10958-1:1998(E) THS under Not for Resale ISO 10958-1:1998(E) Foreword IsO (the International Organization for Standardization) is a worldwide federationofnationalstandardsbodies(lsOmemberbodies).Theworkof preparing International Standards is normally carried out through isO technical committees. Each member body interested in a subject for which a technical committee has been established has the right to be represented on that committee. International organizations, governmental and non- governmental, in liaison with ISO, also take part in the work. IsO collaborates closely with the International Electrotechnical Commission (IEC) on all matters of electrotechnical standardization. Draft International Standards adopted by the technical committees are circulated to the member bodies for voting. Publication as an International a vote. International Standard 10958-1 was prepared by Technical Committee ISO/TC 83, Sports and recreational equipment, Subcommittee SC 4, Skis and snowboards. ISO 10958 consists of the following two parts, under the general title Snowboards -Binding mounting area: Part 1: Requirements and test methods for snowboards without inserts Part 2: Requirements and test methods for snowboards with inserts @ISO1998 All rights reserved. Unless otherwise specified, no part of this publication may be reproduced or utilized in any form or by any means, electronic or mechanical, including photocopying and microfilm, without permission in writing from the publisher. InternationalOrganizationforStandardization Case postale 56 . CH-1211 Geneve 20· Switzerland Internet [email protected] Printed in Switzerland Copyright Intern ational Organizationfor Standardization Not for Resale INTERNATIONALSTANDARD @ISO ISO 10958-1:1998(E) Snowboards Binding mounting area - Part 1: Requirements and test methods for snowboards without inserts Scope This part of IsO 10958 specifies requirements and test methods for binding mounting areas, bindings and retention devices of snowboards without inserts for adults or juveniles, in order to optimize the compatibility of the functional unit"snowboard-binding-boot". It contains data for the manufacturer of snowboards, bindings and retention devices concerning dimensions, tests and other specifications for the binding mounting area. This International Standard is applicable to snowboards of the following nominal lengths: IN ≥ 1 000 mm. For dimensions with no tolerance indicated, a tolerance of ± 1 mm is valid. 2 Normative references The following standards contain provisions which, through reference in this text, constitute provisions of this part oi IsO 10958. At the time of publication, the editions indicated were valid. All standards are subject to revision, and most recent editions of the standards indicated below. Members of IEC and ISO maintain registers of currently valid InternationalStandards Iso 6004:1991,A/pine skis—Ski binding screws—Requirements. Iso 10045:1991, Alpine skis - Binding mounting area - Requirements for test screws. 3 Terms and definitions For the purposes of this part of isO 10958, the following terms and definitions apply. 3.1 insert manufacturer's pattern Copyright Inte lal Organization for Standardizatior