ISO INTERNATIONAL STANDARD 4510-2 Second edition 1996-11-15 Earth-moving machinery -- Service tools -- Part 2: Mechanical pullers and pushers Engins de terrassement --- Outils d'entretien et de depannage Partie2:Extracteursmecaniquespartractionetparpression OSI Reference number ISO 4510-2 1996(E) n for Standardizatior No reproduction or networking permited without license from IHS Provided by IHS und Not for Resale ISO4510-2:1996(E) Foreword IsO (the International Organization for Standardization) is a worldwide fed- eration of national standards bodies (IsO member bodies). The work of which a technical committee has been established has the right to be represented on that committee. International organizations, governmental and non-governmental, in liaison with isO, also take part in the work. isO collaborates closely with the International Electrotechnical Commission (lEC)onallmattersofelectrotechnicalstandardization. Draft International Standards adopted by the technical committees are circulated to the member bodies for voting. Publication as an International a vote. International Standard ISO 4510-2 was prepared by Technical Committee ISO/TC 127, Earth-moving machinery, Subcommittee Sc 3, Operation and maintenance. This ssecond editioncancelsand replaces the first edition (Is0 4510-2:1986), which has been technically revised. ISO 4510 consists of the following parts, under the general title Earth- moving machinery - Service tools: Part 1: Common maintenanceand adjustmenttools Part2:Mechanicalpullers andpushers Annex A of this part of iSO 4510 is for information only @ISO1996 All rights reserved Unless otherwise specified, no part of this publication may be reproduced or utilized in any form or by any means, etectronic or mechanical, including photocopying and microfilm, without permission in writing from the publisher international Organization for Standardization CasePostale56.CH-1211Geneve20.Switzerland Printed in Switzerland Copy inational Organization for Standardization networking permitted without license from IHS Not or Resale ISO 4510-2:1996(E) INTERNATIONALSTANDARD ISO Earth-moving machinery - Service tools - Part 2: Mechanicalpullersandpushers 1 Scope This part of isO 4510 specifies for guidance the types, general requirements and main nominal dimensions of mechanical pullers, attachments and adaptors used for carrying out repair work. This part of IsO 4510 includes mechanical pullers and push pullers, pulling attachments and adaptors which are commonly used for pulling gears and bearings mounted on the types of earth-moving machinery defined in ISO6165. Machine manufacturers should consider and A 5), choosing dimensions for machine design from tables 1 to 4, and specifying, in suitable manuals as described in IsO 6750, the type of tools to be used for carrying out repair work 2 Normative references The following standards contain provisions which, through reference in this text, constitute provisions of this part of IsO 4510. At the time of publication, the editions indicated were valid. All standards are subject to revision, and parties to agreements based on this part of isO 4510 are encouraged to investigate the possibility of applying the most recent editions of the standards indicated below. Members of IEC and IsO maintain registers of currently valid International Standards. IsO 4510-1.1987, Earth-moving machinery Service tools - Part 1: Common maintenance and adjustment tools IsO 6750.1984, Earth-moving machinery—Operation and maintenanceFormat and content of manuals 1)Tobepublished(RevisionofISO61651987) luction or ense from IHS Not for Resale